leWECycleControlWire

leWECycleControlWire( 
) 
=> t / nil

Description

Allows cycling through the extreme and middle control wires in the selected bus during interactive bus editing. This functions runs successfully only when the Create Wire command is active. This function is available only in Layout XL and higher tiers.

You can also cycle through the control wires by using the bindkey Control + Shift + Z.

Arguments

None

Value Returned

t	The command ran successfully.
nil	The command failed to run or an error occurred.

Examples

The following example lets you cycle between the extreme and middle control wires in the selected bus during interactive bus editing.

leWECycleControlWire()

Related Topics

Interactive and Assisted Routing Functions

Using the Control Wire

Return to top