Incomplete Nets Commands
|
Show and hide all the incomplete nets in your design. You can also access this command using:
If you run the Show/Hide All command with the Annotation Browser closed, the command fails. You must open the Annotation Browser before you run the command.
To automatically display all the incomplete nets in the design when the layout is launched in Layout XL, set the environment variable |
|
|
Show and hide the incomplete nets associated with selected objects in your design. You can also access this command using
When you start the command, the Annotation Browser is automatically initialized if required. The command does not support blockage, boundary, or row objects. These objects are silently ignored unless a preselected set contains only unsupported objects, in which case you see a message informing you of this fact. |
|
|
The command behaves differently depending on whether you launch it with objects already preselected or postselected.
See Environment variable: showIncompleteNets |
|
|
Change the visibility of the currently visible incomplete nets in the design canvas. You can also access this command using:
|
|
|
Display incomplete nets that are common between selected instances.
|
Related Topics
Return to top