Mode

Controls how transmission line segments snap to the grid.

Bend Style

Sets the type of corner to use for the bends in the transmission line. You can choose from: bend, chamfer, or radial.

Width

Specifies the transmission line width in user units (typically microns).

Bend Factor

Sets the maximum width allowed in a standard bend before the bend is automatically chamfered. (Available only when Bend Style is bend.)

Chamfer Factor

Sets the fraction of the corner that is removed in a chamfer bend. (Available only when Bend Style is chamfer.)

Radius Factor

Sets the ratio of the centerline bend width to the radial bend width. (Available only when Bend Style is radius.)

Resolution

Sets the number of segments used in a 180-degree radial bend.

Environment variable: trlNPtsToPI